Miele G 690 - To Set the Water Softener; Hardness Level 20-630 Mg;L (1 - 35 °D German Scale)

To set the water softener
Hardness level 20-630 mg/l
(1 - 35 °d German scale)
Switch the dishwasher off.
Use a screwdriver to remove the lid of
the water hardness level selector in
the wash cabinet.
Check that the selector is set to set-
ting 6 (factory setting). If not, use a
flat blade screwdriver or a coin to
turn the selector until it clicks on set-
ting 6.
Press and hold in the "+" and
"START/Stop" buttons, and
at the
same time switch on the dishwasher
with the "ON/OFF " button.
"P" and two figures appear in the
time display.
Press the "UNIVERSAL 55 °" pro-
gramme button.
A figure appears in the display corre-
sponding to the water hardness level
already set, e.g. "22" – the water sof-
tener is set to a water hardness level
of 400 mg/l (22 °d German scale).
Press the "Top Solo" button as many
times as necessary until the water
hardness value required (measured
in °dH) appears in the display.
Example:
For a water hardness level of 540 mg/l
(30 °d German scale).
Keep pressing the "Top Solo" button
until "30" appears in the display.
Once the figure "36" is reached the
counter returns to "1".
Press the “START/Stop” button.
“SP” appears in the time display.
Press the “START/Stop” button again.
All the control lights next to the pro-
gramme selection buttons and the deci-
mal point in the time display light up.
The change to water hardness recogni-
tion is now stored in memory.
Water softener
15