Comparison tests
Test standard: IEC 436 / DIN 44990 / IEC 704 / prEN 50242
Amount washed: 6 place settings (half load)
Programme tested: UNIVERSAL PLUS 55 °
with “Top Solo”
Amount of detergent: 20 g
only in compartment II
Rinse aid dispensing: Setting 3 (approx. 3 ml, set at factory)
Measuring noise: Before starting a programme to measure noise, the
dishwasher door must first be opened completely.
Doing this will automatically close the vent exit for
the turbothermic drying process as in daily use.
Dishwashers with cutlery basket
Spoon inserts: Fit the two inserts on top of the cutlery basket, (see
Section on loading the dishwasher, spoon inserts).
Place three spoons at intervals in each insert.
Upper basket Lower basket
Comparison tests
57
To Next Page
Loading...
Need help?
General
