Programme options
54
Optimise standby
"Optimise standby" is activated by de-
fault.
To save energy the dishwasher will
switch off automatically a few minutes
after the last time a button has been
pressed or after the end of a pro-
gramme.
The dishwasher will not switch off
whilst a programme is running, during
the Delay start period or if there is a
fault.
Optimise standby can be switched off if
you prefer. If you do this the duration
before the dishwasher switches off
automatically increases to approx. 6
hours. Doing this will increase energy
consumption.
Switch the dishwasher off with the
button, if it is switched on.
Press the Start button in and whilst
holding it in switch the dishwasher
on using the button.
Keep the Start button pressed in for
at least four seconds until the Start
indicator light comes on.
If this does not happen, start the pro-
cedure from the beginning again.
Press the button eight times.
The indicator will flash rapidly eight
times at intervals.
The flashing sequence in the display
shows whether Optimise standby is ac-
tivated or not.
– : "Optimise standby" activated
– : "Optimise standby" deactivated
Press the Start button to change the
setting.
The setting is now stored in memory.
Switch the dishwasher off with the
button.
To Next Page
Loading...
Need help?
General
