Problem solving guide
67
Water inlet fault
Problem Cause and remedy
The / indicator
light flashes on and off.
The stopcock is closed.
Open the stopcock fully.
The dishwasher stops
during a programme.
The /indicator
light is flashing.
The fault number or
appears in the dis-
play.
Before rectifying the problem:
Switch the dishwasher off with the button.
The water intake is restricted.
Open the stopcock fully and start the programme
again.
Clean the water inlet filter (see "Maintenance").
The water pressure at the intake is lower than
50kPa (0.5bar).
Seek professional advice.
Water drainage fault
Problem Cause and remedy
The dishwasher stops
during a programme.
The / indicator
flashes.
Fault code shows in
the display.
Before rectifying the problem:
Switch the dishwasher off with the button.
The water outlet is restricted.
There might be water in the wash cabinet.
Clean the filter combination (see "Cleaning and
care, Cleaning the filters").
Clean the drain pump (see "Maintenance").
Clean the non-return valve (see "Maintenance").
Remove any kink or loop in the drain hose.
To Next Page
Loading...
Need help?
General
