Clock/timer
39
Setting the time
The time of day is set in segments:
– For the time of day and cooking dura-
tions, first the hours, then the
minutes.
– For a minute minder duration, first the
minutes, then the seconds.
Confirm withOK.
The respective functions appear de-
pending on the position of the function
selector(,, or).
Highlight the function you want using
the or sensor control.
The appropriate symbol will flash for
approx. 15seconds.
While the symbol is flashing, confirm
with OK.
The function is accessed and the left-
hand numeric block will flash.
You can only set the time while the nu-
meric block is flashing. If the time has
elapsed and the numeric block is no
longer flashing, you have to access
the function again.
Use the orsensor control to set
the value you want.
Confirm withOK.
The right-hand numeric block will flash.
Use the orsensor control to set
the value you want.
Confirm withOK.
The time has now been saved.
Time display
The symbols and or will show
if you have set times.
If you are using the minute minder,
cooking duration and end of cooking
duration functions at the same time,
the last time that you set will be shown.
If you have set a cooking duration, the
time of day will not be displayed.
At the end of the duration
When a duration has elapsed, the ap-
propriate symbol will flash and a buzzer
will sound if the buzzer is switched on
(see “Clock/timer – Changing settings”).
Confirm withOK.
The buzzer will stop and the symbols in
the display will go out.