,
The appliance must not be
operated until it has been correctly
installed in its housing unit.
Otherwise it poses an electric shock
hazard.
To ensure adequate ventilation to
the oven once installed:
– do not fit a rear panel into the
housing unit.
– make sure that the shelf on
which the appliance is placed
does not touch the wall.
– do not fit insulation material
inside the housing unit.
When installing the appliance do not
lift it up by the door handle as this
can damage the door.
,
Turn off the mains electricity
supply to the isolator.
^
Connect the mains cable from the
oven to the isolator.
It is a good idea to remove the door
before installing the appliance. The
oven will then be lighter to lift when you
are positioning it the housing unit and
also it will not be possible to use the
handle to lift it by mistake.
^
Push the appliance back into the
housing unit and align it.
^ Open the door (if you have not
removed it previously).
^
Use the screws supplied to secure
the appliance to the side walls of the
housing unit through the holes in the
oven trim.
^
Replace the door (if you removed it
before installing the appliance). See
"Cleaning and care - To refit the
door").
Installing the oven
75
To Next Page
Loading...
Need help?
General
