To change the "status" of a
setting
^
Select "% Settings".
^
Touch the OK sensor.
PI
"PI" will appear in the display.
^
Touch the V or W sensor repeatedly
until the setting required appears in
the display.
^ Touch the OK sensor.
S0
The current status "S" of the setting will
appear in the display.
^
Use the V or W sensor to change the
status.
^
Touch the OK sensor.
The change to the status is then stored
in memory.
"P" will appear in the display again
together with the number for the setting.
You can alter more settings as long as
the function selector is not turned to "0".
The changes remain in memory
even after a power cut.
% Settings
31
To Next Page
Loading...
