Installing the oven
97
The oven must not be operated
until it has been correctly installed in
its housing unit.
In order to function correctly, the
oven requires an adequate supply of
cool air.
Ensure that the supply of cool air is
not impaired (e.g. by heat insulation
strips in the housing unit).
Please also ensure that the cool air
supply is not unduly heated by other
heat sources such as a solid fuel
stove.
Before installation
Before connecting the appliance to
the mains, you must disconnect the
power supply to the isolator switch or
fused spur connection unit.
Building in
Connect the mains cable from the
oven to the isolator.
Do not carry the oven by the door
handle. The door can be damaged.
Use the handles on each side of the
casing to carry it.
It is advisable to dismantle the door
before installing the appliance (see
"Cleaning and Care - Dismantling the
door") and remove accessories from
the oven cavity. This will make it easier
to install in its niche and you will not
be tempted into using the handle to
carry it.
Push the oven into the housing unit
and align it.
Open the door (if you have not
removed it previously).
Use the screws supplied to secure
the oven to the side walls of the
housing unit through the holes in the
oven trim.
Refit the door, if necessary (see
"Cleaning and care - Refitting the
door").
To Next Page
Loading...
Need help?
General
