Before using for the first time
27
Setting the rinse aid dosage
You can adjust the rinse aid dosage for
best results.
Th
e rinse aid dosage can be set from
a
p
prox. 0-6 ml. It is set to a recommen‐
ded setting of approx. 3 ml at the facto‐
ry.
If the function to adjust the Sensor
was
h p
rogramme has been activated,
the amount of rinse aid dispensed in
the Sensor wash programme can be
higher than that set.
If spots appear on crockery and glass‐
war
e
:
I
ncrease the rinse aid dosage.
If clouding or smearing appears on
c
r
ockery and glassware:
Decr
ease the rinse aid dosage.
Switch the dishwasher off with the
bu
tton, if it is switched on.
P
ress the programme selector button
in, and whilst holding it in switch
the dishwasher on using the but‐
ton.
Keep the programme selector button
pressed in for at least four sec‐
onds until the lower right hand pro‐
gramme indicator comes on.
If this does not happen, start the proce‐
dur
e fr
om the beginning again.
P
ress the Sho
rt button 3 times.
The Short indicator will flash rapidly 3
time
s at intervals.
The dosage set will show in the display
aft
er the
symbol.
The factory default setting of will
appear in the display.
T
his indicates a setting of 3 ml.
U
se the programme selector button
to select the rinse aid dosage you
want.
The dosage amount alters each time
you press the button.
The setting is now stored in memory.
Switch the dishwasher off with the
butt
on
.
To Next Page
Loading...
Need help?
General
