Programme options
52
Optimise standby
"Optimise standby" is activated by de‐
fault.
To save energy the dishwasher will
sw
i
tch off automatically a few minutes
after the last time a button has been
pressed or after the end of a pro‐
gramme.
The dishwasher will not switch off
whilst a progr
amme is running, during
the Delay start period or if there is a
fault.
Optimise standby can be switched off if
you prefer
. If you do this the duration
before the dishwasher switches off in‐
creases to 6 hours. Doing this will in‐
crease energy consumption.
Open the door
.
Switch the dishwasher off with the
butt
on, if it is switched on.
P
ress the programme selector button
in, and whilst holding it in switch
the dishwasher on using the but‐
ton.
Keep the programme selector button
pressed in for at least four sec‐
onds until the lower right hand pro‐
gramme indicator comes on.
If this does not happen, start the proce‐
dur
e fr
om the beginning again.
Press the Short button 8 times.
The Shor
t indicator will flash rapidly 8
times at int
ervals.
The flashing sequence in the display
shows whether Optimise standby is ac‐
tivat
ed or not.
– : "O
ptimise standby" is activated
– : "Optimise standby" is switched
off
Press the programme selector button
if you wish to change the setting.
The setting is now stored in memory.
Switch the dishwasher off with the
butt
on.
To Next Page
Loading...
Need help?
General
