With the help of the following notes, minor faults in the performance of this
appliance, some of which may result from incorrect operation, can be put right
without contacting the Service Department.
,
Repair work to electrical appliances should only be carried out by a
suitably qualified person in strict accordance with current local and national
safety regulations. Repairs and other work by unqualified persons could be
dangerous. The manufacturer cannot be held liable for unauthorised work.
Problem Possible cause Remedy
The ironer will not
work.
There is no power to
the appliance.
Check whether
- the mains plug is plugged in
and switched on.
- the fuse or circuit breaker has
tripped.
Laundry does not pass
smoothly through the
roller.
The roller cover is
dirty.
Wash the cover at 60°C.
Laundry does not pass
smoothly through the
roller.
There are calcium
deposits (from hard
water) or starch
residues on the
heater plate.
Remove these with household
washing-up liquid or a suitable
proprietary cleaning agent.
Folds have formed in
the roller cover.
The heater plate is
dirty (calcium
deposits).
Clean the heater plate with
household washing-up liquid or
a suitable proprietary cleaning
agent.
The roller cover is very
dirty.
Starch deposits etc. Wash the cover at 60°C.
The heater plate has
no contact pressure.
The emergency
release catch has
been pulled up.
Push the emergency release
catch down (see also "Power
cut").
Problem solving guide
23
To Next Page
Loading...
Need help?
General
