Operation
53
Switching on the dishwasher
Turn on the tap if it is turned off.
Open the door.
Make sure the spray arms can rotate
freely.
Touch the sensor.
If the dishwasher has been switched
off for longer than 1minute, you will
need to touch the sensor for
slightly longer (wipe protection).
When a programme is selected, it will
appear briefly in the display and the
appropriate sensor will be illuminated.
Next, the estimated water consumption
may be shown for the selected
programme for several seconds.
Then the display will show the
estimated duration for the selected
programme.
Selecting a programme
Choose your programme according to
the type of crockery and the degree of
soiling.
The different programmes and their
uses are described in the Programme
chart later on in this booklet.
Touch the sensor for the required
programme.
The sensor for the selected programme
will light up.
Further programmes can be selected
under .
To do so, touch the sensor.
The first of the further programmes will
appear in the display.
Use the sensors in the display to
select the programme you want.
You can now select programme options
(see "Programme options").
If any programme options are selected,
the appropriate sensor will light up.
To Next Page
Loading...
Need help?
General
