Operation
54
Display of programme duration
The estimated duration of the selected
programme appears in the display
before the programme starts. If the door
is opened during the programme, the
time left until the end of the programme
is displayed.
Symbols appear to indicate which stage
the programme is at:
Pre-wash / Soak
Main wash
Interim rinse
Final rinse
Drying
Finish
The displayed duration may vary for the
same programme. It is influenced by,
for example, the temperature of the
incoming water, the reactivation cycle
of the water softener, the amount of
crockery and how soiled it is.
When a programme is selected for the
first time, the display will show the
average programme duration for a
warm water connection.
The programme durations shown in the
“Programme chart” refer to standard
test loads and temperatures.
Each time a programme is run, the
control module calculates the
programme duration depending on the
temperature of the water taken into the
dishwasher and the size of the load.
Starting a programme
Start the programme by closing the
door.
Confirm the previously displayed
message with OK.
The in-operation indicator light comes
on to show that a programme has been
started.
If the door is opened during a
programme, you can display the name
of the current programme by pressing
OK.
Risk of scalding due to hot
water.
During operation, water in the
dishwasher may be very hot.
Only open the door if absolutely
necessary and exercise extreme
caution when doing so.
To Next Page
Loading...
Need help?
General
