Cleaning the water inlet filter
A filter is incorporated in the screw
connection of the valve on the water
inlet hose. The filter must be cleaned
when dirty, otherwise insufficient water
flows into the wash cabinet.
,
The plastic housing of the water
connection contains an electrical
component. The housing must not
be dipped in water.
Recommendation
If the mains water contains a large
number of insoluble substances, we
recommend fitting a large-area filter in
the connection between the stopcock
and the water inlet hose threaded
union. This filter is available from the
Miele Spares Parts dept.
Cleaning the filter:
^ Switch the dishwasher off and
disconnect it from the mains.
^
Close the stopcock.
^
Unscrew the inlet hose.
^
Carefully remove the seal.
^ Withdraw the filter using pointed
pliers and rinse clean under running
water.
^ Take care when withdrawing the filter
not to pull out or dislodge the flow
regulator located underneath the
filter.
^ Replace the filter and seal, making
sure they are sitting correctly.
^
Reconnect the inlet hose to the
stopcock, making sure it goes on
correctly and is not cross-threaded.
^
Turn on the stopcock gradually to
test for leaks. If there is a leak, the
inlet hose might not be on securely,
or it may have been screwed on at an
angle. Unscrew and reconnect the
water inlet valve correctly.
Maintenance
56
To Next Page
Loading...
Need help?
General
