Detergent amount
This function will only be visible if the
External dispenser option has been
activated.
For dispensing liquid detergent via the
G 60 Semi Dos Module you can set the
dosage in millilitres or as a percentage
depending on the detergent
manufacturer's specifications
–
Specified in ml
30 ml is the factory default.
The dosage can be altered in 2 ml
stages from 10 - 100 ml.
–
Specified as a percentage
0.50 % is the factory default.
The dosage can be altered in stages
of 0.03 - 0.04 % from 0.17 - 1.67 %.
^ Select the setting you want, and
confirm your selection with the
middle button.
Venting the dispensing system
The dispensing system will only
dispense reliably when there is no air in
the system.
The dispensing system must be vented
if:
–
the dispensing system is being used
for the first time,
–
the liquid detergent container has
not been refilled in time and the
dispensing system has emptied.
,
In order to ensure that the
dispensing system functions
correctly, check before venting that
the liquid detergent container is
filled sufficiently and that the
dispensing lance is connected to
the container securely.
^ Select
Start venting and confirm
your selection with the middle button.
The venting process will begin. The
time remaining will appear in the
display.
As soon as the venting process is
completed you will be prompted to run
the Pre-wash programme. Start the
programme in order to remove any
traces of liquid detergent.
Settings menu
74
To Next Page
Loading...
Need help?
General
