Function buttons
fStop/End
The function button on the right-hand side is used to
stop a program after it has started. Pressing it again
finishes the program.
[ Block plus
The relevant program block (e.g. Pre-dry) is added to
the program.
FC Settings
Press this button to switch to another
language temporarily.
m Start time
Pressing this button before the start of a program dis
-
plays the message that a start time can be selected.
K Information
Press this button to call up program
information in the display.
ü Change order of program structure
The order of the program in progress can be chang
-
ed or program blocks can be repeated.
A Back
Takes you back to the previous display.
e/- Indicates that there is more
information on next or previous line.
S Save
See the programming instruction booklet.
$ Programme locked
Once a locked program has been started, the End
button can only be used to stop and cancel it during
the first minute.
% Programme unlocked
\ Operating data
Data transfer
Chip card operation
The chip card is supplied without any programs.
See the programming instruction booklet for informati
-
on on transferring data from the control unit to the
chip card and vice versa.
The chip card can store a maximum of 30 programs,
each with 6 blocks.
The back of the chip card can be labelled.
9
Guide to the machine
To Next Page
Loading...
Need help?
General
