Detergent dispensing
Please follow the detergent
manufacturer's instructions.
Instructions for use and recommended
amounts for a full load are given on the
detergent packaging.
The right amount to dispense will
depend on the following:
–
The size of the load
–
The soiling level of the laundry
– The water hardness level.
Check with your local water supplier
if you do not know the hardness level
in your area.
The water hardness level
Hardness-
range
mmol/l German scale
°d
I (soft) 0 - 1.5 0 - 8.4
II (medium) 1.5 - 2.5 8.4 - 14
III (hard) Above 2.5 Above 14
Water softeners
A water softener can be used to cut
down on the use of detergents in hard
water areas. Dispense according to the
amount specified on the packaging.
First add detergent and then the water
softener.
Use a quantity of detergent as for soft
water.
Washing with several
components
If you wash using several components
(e.g. special application detergents),
we recommend always dispensing the
agents into compartment j in the
following order:
1. Detergent
2. Water softeners
3. Stain remover
This way the agents are distributed
more evenly.
Colour run and dye removers/
dyes
^ Do not use
colour run or dye
removers in this machine.
Dyes suitable for use in a washing
machine can be used. However, please
note that the salt used in the dyeing
process can cause corrosion to
stainless steel components in the
machine if you dye frequently. Always
observe the manufacturer's instructions
carefully.
Detergent
35
To Next Page
Loading...
Need help?
General