Installation
44
Unscrew the screws at the bottom of the back panel and remove
the panel.
Loosen the hexagonal screws to remove the shipping struts.
Keep the shipping struts. They must be re-assembled before trans-
porting the machine.
Water connection
Water pressure (flow pressure) of a minimum 14.5 psi (100 kPa)/max.
145 psi (1000 kPa) is required to guarantee problem free program
operation.
The machine must be connected to the water supply using the inlet
hoses provided.
Hoses must be replaced with hoses tested for a burst pressure of at
least 1015 psi (7000kPa) overpressure and for water temperatures of
a minimum of 194°F / 90°C.
This also applies for associated connection fittings. Miele original re-
placement parts fulfil these requirements.
Tip: The hot water supply must not exceed a maximum temperature
of 158°F / 70°C.
To Next Page
Loading...
Need help?
General
