Fitting the front panel
The appliance front can be fitted with a
door panel to match other kitchen units.
If fitted in a Miele kitchen, the door
panel can be ordered pre-drilled with
the necessary fixing holes.
If fitted in a non-Miele kitchen, a
suitable panel will have to be drilled
to suit by a qualified kitchen fitter.
See "Fitting a door front panel made
by another manufacturer" for details
on preparing and drilling the fixing
holes.
Front panel dimensions
Width
: 592-596 mm
Thickness
: 17 to 19 mm (corresponding
to the thickness of the adjacent unit
door front panels)
Height
: The height of the door front
panel corresponds to the door height
(H) of the adjacent units.
Fitting the front panel
^
Open the door.
^
Hold the front panel in the correct
position in front of the appliance
door.
^ Screw the front panel to the machine
door.
If all the spacer bars have been
removed:
You can also make use of the 3 holes at
the top of the door plate to screw the
front panel to the door plate.
Installation
44
To Next Page
Loading...
Need help?
General
