Problem solving guide
68
Many malfunctions and faults that can occur in daily operation can be easily
remedied. You can save time and money in many cases, as you do not need to call
the Miele Customer Service Department.
Information to help you rectify faults yourself can be found at www.miele.com/ser-
vice.
The following tables are designed to help you to find the cause of a malfunction or
a fault and to resolve it.
Fault messages shown in the display when a programme is
cancelled
Message Cause and remedy
Empty the container
or check the drain
outlet
The condensed water container is full or there is a
kink in the drain hose.
Open and close the door with the tumble dryer
switched on to clear the message. Or switch the
tumble dryer off and then on again.
Empty the condensed water container.
Check the drain hose.
Obstruction detec-
ted. Untangle laun-
dry and restart.
The laundry is unevenly distributed or has rolled up.
Open the door and loosen the laundry. If neces-
sary, take out some of the laundry.
Switch the tumble dryer off and then on again.
Start a programme.
Fault F. If restart
fails, call Service.
There is no obvious cause.
Switch the tumble dryer off and then on again.
Start a programme.
If the programme is cancelled again with the same
fault message, then there is a fault. Contact the Miele
Customer Service Department.
To Next Page
Loading...
Need help?
General
