Settings
98
“Display” off status
To save energy the display and sensor
controls will go out after 10minutes
and the Start/Stop button will flash
slowly. You can change this setting.
Options
- On
The display will go out (after
10minutes):
– if a programme is not selected
after the dryer has been switched
on
– while the programme is running
– after the end of a programme
- On. Not in current prog.
(Factory default)
The display will go out (as described
above) but will remain on while the
programme is running.
You can switch the display back on by
touching any sensor.
To Next Page
Loading...
Need help?
General
