Energy saving tips
27
Feedback
You can view information about the en-
ergy consumption of your tumble dryer
with the sensor.
The following information will appear in
the display:
- An estimate of the energy consump-
tion before the programme begins.
- The actual energy consumption dur-
ing the programme or at the end of
the programme.
1. Viewing the estimated consump-
tion
After selecting a drying programme,
touch the sensor.
The estimated energy consumption
level will be displayed as a bar chart.
The more bars visible (), the higher the
energy consumption.
The estimate will vary depending on the
drying programme, temperature and
any options selected.
Touch the OK sensor or wait until the
display automatically returns to the
standard display.
2. Viewing the actual consumption
The actual energy consumption can be
viewed during the programme or at the
end of the programme.
Touch the sensor control.
If the energy consumption is too low,
<0.1kWh will be displayed. The con-
sumption will alter as the programme
progresses.
It is also possible to view the degree
of soiling of the filter as a% at the end
of the programme before you open the
door.
Touch the sensor to switch to the
Filter display.
0% = lightly soiled, 50% = moderately
soiled, 100% = heavily soiled.
Increased soiling will cause the pro-
gramme duration to increase which in
turn will increase energy consumption.
If the door is opened or the appli-
ance has switched off automatically
at the end of the programme, the
data will revert to the estimated con-
sumption.
Tip: You can view the consumption
data for the last drying programme in
Settings under Consumption.
To Next Page
Loading...
Need help?
General
