Settings
93
Conductivity
This setting is only relevant for regions
with very soft water.
Very soft water can result in unsatis-
factory drying results.
You should only select this setting if
the water used for washing the laun-
dry is extremely soft with a conduct-
ivity reading (electrical conductivity)
less than 150μS/cm. Contact your
local water authority for the conduct-
ivity level of your mains water supply.
Selection
- Normal (factory default setting)
- Low <150ms (only for regions with
very soft water)
Consumption data
You can view information about the
energy consumption of your tumble
dryer with the sensor. Various in-
formation can be shown in the display.
Options
- Estim. + Consump. (factory default)
– Indicates the estimated energy
consumption before the pro-
gramme starts
– Indicates the energy consumption
once the programme starts
- Estimate
Only indicates the estimated energy
consumption before the programme
starts
When this option is activated, Con-
sumption is no longer shown in the
display.
Consumption
You can display the total consump-
tion.
Selection
- Previous programme
Displays energy consumption in the
last programme run
- Total consumption
Displays the total consumption to
date
- Reset function
Deletes the total consumption to date
To Next Page
Loading...
Need help?
General
