Problem solving guide
70
Replacing the plinth filter
The heat exchanger can clog up.
Replace the plinth filter immediately
if you see the following signs of wear
before or after cleaning (optional ac-
cessory).
Poor fit
The edges of the plinth filter do not sit
properly and the plinth filter is out of
shape. Fluff will blow into the heat ex-
changer unfiltered through edges that
do not sit properly. This will, in time,
cause a blockage in the heat ex-
changer.
Deformations
Deformations indicate that the filter has
become blocked and worn by continu-
ous use.
To Next Page
Loading...
Need help?
General
