Problem solving guide
74
Replacing the condensed wa-
ter spray jet
When certain programmes are being
used, water is taken from the con-
densed water container and sprayed
into the drum. The spray jet can some-
times stop working. Limescale depos-
its have built up on the spray jet.
Remove the spray jet (optional ac-
cessory). Replace the spray jet.
You can only replace the spray jet us-
ing a special tool. The special tool is
supplied with the new spray jet.
Using the wrong tool can cause
damage.
Doing so can damage the spray jet
or the tumble dryer.
Only use the tool supplied. Do not
use any other tool.
Open the tumble dryer door.
The spray jet is located in the top left of
the door opening.
Attach the tool to the spray jet.
Turn the tool anti-clockwise to un-
screw the spray jet.
Insert the new spray jet into the tool.
Turn the tool clockwise to screw the
spray jet securely in position.
The tumble dryer must not be oper-
ated without the spray jet fitted.
To Next Page
Loading...
Need help?
General
