Frequently Asked Questions
With the help of the following guide minor faults in the performance of the
machine, some of which may result from incorrect operation, can be remedied
without contacting the Service Department.
This guide may help you to find the reason for the fault, and how to correct it.
Indicator lights or information on the time display
Problem Possible cause and solution
The indicator light
comes on after a
program has been
cancelled and a signal
sounds.
The condensed water container is full or there is a
kink in the drain hose.
Empty out the condensed water container.
Check the drain hose.
See “Cleaning and care”.
To switch the indicator light off:
Open and close the door (with the dryer switched
on).
The indicator light
comes on at the end of
the program.
There is a build-up of lint in the airways.
Clean the lint filters.
Clean the plinth filter.
See “Cleaning and care”.
To switch the indicator light off:
Open and close the door (with the dryer switched
on).
You can influence when the indicator light comes
on: See “Programmable functions”, “ Airway
indicator”.
lights up. The program selector has been moved.
Select the original program. The time left will
appear on the display again.
Bars flash on the
display at the end of a
program:
.........
The program has finished but the laundry has not yet
cooled down.
Either remove the laundry and spread it out to cool
down or leave it in the tumble dryer to cool down
during the cooling phase.
46
To Next Page
Loading...
Need help?
General
