Miele TWB 120 WP User Manual

Programmable functions
74
 Display switch-off status
To save energy, the time display and
sensor buttons will go out after
10minutes, and only the Start/Stop
sensor button will flash. You can alter
this setting.
However, there is no switch-off in the
event of a fault.
Options
 = Off
The time display and sensor
buttons will remain lit up while
the dryer is switched on.
 = On (factory setting)
The time display and sensor
buttons will go out after
10minutes. . .
. . . if no further selection is
made after switching the dryer
on.
. . . after a program has
started.
However, the time display and
sensor buttons will remain lit
up for 10minutes after a delay
start time has elapsed, after
the end of a program, or at the
end of the Anti-crease phase.
“Switching on” the display again
– Turn the program selector to any
position (other than ) or touch a
sensor button. This will not alter a
running program.
– Open the door while the dryer is
switched on.
 Appliance switch-off
The dryer switches off automatically
after 15minutes to save energy. This
time can be extended or reduced.
The dryer will switch off automatically
after 15, 20, or 30minutes
– if no further selection is made after
switching the dryer on,
– following the end of the Anti-crease
phase,
– after a program without an Anti-
crease phase has finished.
However, there is no switch-off in the
event of a fault.
Options
 = After 15minutes (factory
setting)
 = After 20minutes
 = After 30minutes

Miele TWB 120 WP Specifications

General

Brand	Miele
Model	TWB 120 WP
Category	Dryer
Language	English