Problem solving guide
45
With the help of the following guide, minor faults in the performance of the
appliance, some of which may result from incorrect operation, can be remedied
without contacting Miele. This will save you time and money because you won't
need a service call.
Please note that a call-out charge will be applied to unnecessary service visits
where the problem could have been rectified as described in these operating
instructions.
Indicator lights or information in the time display
Problem Possible cause and remedy
The indicator light
comes on at the end of
the programme.
The tumble dryer is not working correctly or
economically. Possible causes could be clogging
caused by fluff or detergent residues.
Please see "Cleaning and care" for notes on
cleaning.
Clean the fluff filters.
Also check the plinth filter and clean it if
necessary.
To turn the indicator light off: Open and close
the door while the dryer is switched on.
You can influence when the indicator light comes
on.
Follow the instructions in "Programmable functions
- Airways indicator".
and light up after
a programme has been
cancelled, a signal
sounds.
The system is clogged by fluff or detergent residues.
To switch off : Switch the tumble dryer off
and back on.
Clean the fluff filters and the plinth filter.
Please see "Cleaning and care" for notes on
cleaning.
Check that the fluff filters and the plinth filter are
not damaged or worn.
If all fluff filters are damaged, deformed or cannot be
cleaned anymore, they must be replaced. For
information on when to replace a plinth filter that is
not functioning properly, refer to "Problem solving
guide - Replacing the plinth filter".
To Next Page
Loading...
Need help?
General
