Miele TWR 780 WP User Manual

Installation
*INSTALLATION*
81
Installation
Levelling the tumble dryer
Ensure that no closeable door, slid-
ing door or oppositely hinged door is
installed that could hinder opening of
the tumble dryer door in any way.
To ensure proper operation, the tumble
dryer must stand perfectly level. The
screw feet on the tumble dryer can be
adjusted to compensate for unevenness
in the floor.
 Turn the screw feet by hand or with a
flat open spanner.
Downtime after installation
 Damage to the tumble dryer by
switching it on too soon.
This can damage the heat pump.
After setting up the tumble dryer wait
for at least one hour before switching
it on.
Ventilation
The cool air intake at the front of the
tumble dryer must not be blocked or
covered. This would hinder a suffi-
cient intake of cool air for the heat
exchanger.
Do not block the gap between the
bottom of the tumble dryer and the
floor with plinth facings, deep pile
carpet etc. This would hinder a suffi-
cient flow of air to the tumble dryer.
The hot air that is blown out from the
heat exchanger warms the room air. En-
sure sufficient ventilation of the room:
e.g., open the window. The drying time
will otherwise take longer (higher energy
requirement).
Before moving the tumble dryer
again (e.g. when moving house)
After each use a small quantity of con-
densed water will collect in the area of
the pump. This water can run out if the
tumble dryer is tipped up when it is be-
ing moved. Recommendation: run the
Warm air programme for approximately
1minute before moving the tumble
dryer. Any remaining condensed water
will then be fed into the condensed wa-
ter container or out through the drain
hose.

Miele TWR 780 WP Specifications

General

Door color	Chrome
Door hinge	Left
Cord length	2 m
Control type	Buttons, Touch
Loading type	Front-load
Drying system	Heat pump
Product color	White
Reversible doors	Yes
Appliance placement	Freestanding
Cycle time	220 min
Noise level	62 dB
Drying class	A
Drum capacity	9 kg
Refrigerating medium	R134a
Number of drying programs	20
Self-cleaning	-
Delay start (max)	24 h
Near Field Communication (NFC)	No
Current	10 A
Heat source	Electric
Connected load	1100 W
AC input voltage	220 - 240 V
AC input frequency	50 Hz
Energy consumption	1.47 kWh
Energy efficiency scale	A+++ to D
Annual energy consumption	174 kWh

Weight and Dimensions

Depth	643 mm
Width	596 mm
Height	850 mm
Weight	62000 g
Depth with door open	1077 mm