Adjust collective travel
Please set the desired collective travel here. The range for
this is optimal between 80 and 100. You may reduce (but not
increase) the pitch values later in your transmitter using the
pitch curve function, e. g. if you measure different angles for
maximum positive and maximum negativ collective. Check
that your transmitter output doesn‘t exceed 115 % of travel
in any case.
Adjust cyclic throw
Adjust cyclic throw here to the indicated value. The range
between 80 and 110 is optimal.
Tail
The last step in the programming assistant is for the tail
settings. Please rst choose the tail servo type used in your
model, then connect the tail servo to the VBar by plugging the
servo into the slot in the VBar labeled “Tail”, to avoid servo
damage.
Finally you should check if stick travel and tail rotor travel cor-
respond properly. If they do not, it is necessary to reverse the
function in the software. The servo limits are set separately
for each direction. For top performance, the values should be
approximately equal for both directions. If that is not possible,
move the servo arm by one notch around the center postion
and try again.
Programming is now nished. Go back to the main page by
clicking Finished.
To Next Page
Loading...
Need help?
General
