Mimosa Backhaul and B24 Help Content
Mimosa Backhaul Management
Copyright © 2018 Mimosa Page Page 55
Network Interfaces
B5
Ethernet Speed - Set the Ethernet port transfer rate or allow it to be automatically determined. Manually
●
selectable options are 10, 100, or 1000BaseT at either full or half duplex. Note that Auto or 1000BaseT/Full is
recommended so that the Ethernet port does not create a bottleneck.
Autoneg Mode - On B5/B5c or B5-Lite, select an autonegotiation mode for Ethernet: Auto, Manual Slave, Manual
●
Master, Preferred Slave, Preferred Master. The Manual Slave option improves interoperability with some routers
and switches.
B11
Fiber Port - Enable this option to route all data through this port with optical fiber and a small form-
●
factor pluggable (SFP) media adapter. After enabling the Fiber Port, the Ethernet cable must remain connected
to supply power, but it does not pass data. If fiber is enabled and connectivity is lost, the radio may still be
accessed via the 2.4 GHz wireless interface.
Fiber Speed - Set the port transfer rate or allow it to be automatically determined. Manually selectable options
●
are 10, 100, or 1000BaseT at either full or half duplex. Note that Auto is recommended so that the Ethernet port
does not create a bottleneck.
To Next Page
Loading...
Need help?
General