Mimosa Backhaul and B24 Help Content
Mimosa Backhaul Mounting & Grounding
Copyright © 2018 Mimosa Page Page 4
Installation, Mounting and Alignment
You will need a 10mm wrench, a #5 hex wrench/allen wrench, and a 5/16 nut driver to mount and align the1.
B24.
Take the mounting bracket and attach it to the B24 using the two provided screws. Use your 10mm wrench2.
to tighten the screws down. When you’re ready to adjust elevation, these two screws will need to be
loosened up.
Add both hose clamps to the B24 mount when you’re ready to mount to a pole, j-mount, etc.3.
Once on the pole, tighten down your hose clamps most of the way so that they hold the radio up on the pole.4.
To Next Page
Loading...
Need help?
General