EasyManuals Logo
Home>Minelab>Metal Detector>E-Trac

Minelab E-Trac User Manual

Minelab E-Trac
49 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #32 background imageLoading...
Page #32 background image
58
59
4 Press either the Left or Right Navigation
Button to change the Threshold Level
5 Press the ‘Detect button to exit the Menu
and resume detecting
Audio Menu
Adjusting Threshold Level:
1 Press the ‘Menu’ button
2 Scroll across toAudio’ (using the Right or
Left Navigation Button)
3 Scroll down to ‘Threshold Level’ (using the
Down Navigation Button)
If the Threshold Level is too low, the slight
variation caused by a small or deep target
may not be sufficient to hear. Adjusting the
level to below an audible level will ensure
silent operation but could mask the audio
response from small targets.
Too High
Audio range
that you are able
to hear.
Small signal
masked
Loud signal
just audible
Threshold Level
Threshold Level
Range: 1–50
Factory Preset: 30
The constant background ‘hum produced by
the detector is called the Threshold. Variations
in the Threshold help you to hear very small
and deep targets. When a rejected target
is detected, the Threshold sound ‘blanks’
(becomes silent) indicating that an undesired
target is underneath the coil.
The Threshold is controlled by Threshold
Level and Threshold Pitch (p. 69). The
correct setting of both Threshold settings will
depend on your hearing and environmental
noise such as wind, waves and machinery.
The Factory Preset for Threshold Level is set
at an appropriate level for E-Tracs built-in
speaker. If the Threshold is too loud whilst
using headphones, use the Threshold Level
setting to reduce the volume.
Too Low
Small signal
now inaudible
Loud signal
Audio range
that you are able
to hear.
Threshold Level
Just Right
Small signal Very loud
signal
Audio range
that you are able
to hear.
Threshold Level
If the Threshold Level is too high, accepted
targets will be harder to hear above the
Threshold ‘hum. Small target responses will
become difficult to hear as the Threshold
nears a maximum setting of 50 when there
will be a persistently loud Threshold ‘hum.
Adjust the Threshold Level to a faint, audible
hum. This will highlight variations in signal
response which may indicate the presence
of a target. If the soil conditions change the
Threshold Level may need adjustment.

Other manuals for Minelab E-Trac

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Minelab E-Trac and is the answer not in the manual?

Minelab E-Trac Specifications

General IconGeneral
Transmission TechnologyFull Band Spectrum (FBS) Multifrequency Technology
Microprocessor32bit, 48MHz microprocessor – fast and powerful
CoilUltra-lightweight 11” Double D (DD) waterproof coil
ConnectivityUSB connector for communication with Personal Computer
SoftwareIntuitive User Interface; Fast Target processing; Multi-language functionality
QuickMask™Fast and Easy adjustment of Ferrous and Conductivity Discrimination
User Modes4 Minelab Modes and 4 My Modes
Depth GaugeAccurate Gauge active in Normal detecting and Pinpoint mode
PinpointNon-motion with modulated audio and visual Crosshair on LCD, 2 Modes – Normal and Sizing
Discrimination2 Dimensional Smartfind™ Discrimination
Target Identification2 Dimensional Smartfind™ Size / Conductivity and Ferrous characteristics Conductivity 1-50, Ferrous 1-35
Sensitivity AdjustmentFully Automatic; adjustable to be more aggressive or conservative, Manual Setting 1-30
Sensitivity GaugeAuto Level, Manual Level, Suggested Level
ThresholdFine adjustment level from 1-50
Recovery SpeedSelectable Fast & Deep
Trash DensityLow for areas with isolated targets or High, for areas with more trash
Noise CancelAutomatic & Manual selection of 11 channels
Audio Response4 Settings: Normal, Long, Smooth, Pitch Hold
Tone ID Number of Tones1, 2, 4 and Multi-tone; customizable for Conductivity or Ferrous response
Tone ID Variability30 adjustable steps for better Target Identification
HeadphoneInput ¼” 100Ω Stereo Jack
Ground Balance ModesAuto Ground Compensation - Advanced Digital Filtering
Ground SettingsNeutral for most ground conditions, Difficult for more mineralized soils
Batteries1600 mAh NiMH or Alkaline batteries
Low Battery Audio AlarmAudio and visual indication
Visual DisplayLarge 3.4” (8.65cm) greyscale LCD panel with Contrast adjustment and Backlight
PatentsUS 4890064; US 5537041; US 5506506

Related product manuals