8 | minnkotamotors.com
©2019 Johnson Outdoors Marine Electronics, Inc.
INSTALLATION
g. With the Right Sideplate laying flat, and the CoPilot
receiver that was just installed facing upwards,
route the yellow wire antenna around the pegs
protruding from the Right Sideplate along the right
and bottom edge of the CoPilot Receiver. Follow the
grooves in each of the pegs.
h. Deploy the motor.
i. On the mount, lift the Center Housing to access
the components below. The Center Housing can be
released by depressing the tabs on each side that
keep it latched to the Base Extrusion.
e. Turn the Right Sideplate over and position the
CoPilot Receiver (Item #2) on the inside of the
Right Sideplate so that the receiver mounting holes
are aligned with the Sideplate Mounting Holes.
Position the wires so that they pass to the right
of the CoPilot Receiver. This should consists of a
Foot Pedal Connection, a Power Connection and an
Antenna wire.
f. Using the two #8 x 5/8’’ screws (Item #1) provided,
insert the screws through the receiver and into
the Right Sideplate. Be sure that the wires are not
pinched in the Sideplate Mounting Holes when
tightening the two screws. Do not over tighten.
ITEM(S) NEEDED
#1 x 2 #2 x 1
CoPilot Receiver
CoPilot Receiver
CoPilot Receiver
Power Connection
Screws
Power Connection
Power Connection
Center
Housing
Foot Pedal
Connection
Foot Pedal
Connection
Foot Pedal
Connection
Foot Pedal
Connection
Motor
Cable Plug
Power Cable
Sideplate
Mounting Holes
Right Sideplate
Antenna
Antenna
Right Sideplate
Right Sideplate
Right Sideplate
Left
Sideplate
Power
Connection
Base
Extrusion
5
4e
4f
5g
5i
4
To Next Page
Loading...
Need help?
General
