minnkotamotors.com | 9
©2019 Johnson Outdoors Marine Electronics, Inc.
INSTALLATION
j. Once lifted, using a #3 Screwdriver, remove the single
screw holding the Strain Relief Bracket in place.
k. Release the Power Cable and Motor Cable Plug from
the Strain Relief Bracket.
l. Connect the Motor Cable Plug that was previously
connected to the Foot Pedal to the CoPilot receiver
Power Connection that has the female receptacles.
m. The Foot Pedal Connection from the CoPilot
receiver can be connected to the Foot Pedal once
the installation is complete.
n. Place the Power Cable and the Foot Pedal
Connection from the CoPilot Receiver on the Base
Extrusion so that it can be captured in the Strain
Relief Bracket.
o. Using a #3 Screwdriver, replace the screw that was
holding the Strain Relief Bracket in place.
p. Be sure that the wires are routed in a way that they
can not be pinched and reseat the Center Housing
in place.
NOTICE: The wires should pass under the Center
Housing over the Base Extrusion in the notch
that creates a separation from the base and the
housing. The connection between the Motor Cable
Plug and the Power Connection should be under
the Center Housing when it is seated.
Strain Relief
Bracket
Screw
Power Cable
Power Cable
Foot Pedal
Connection
Foot Pedal
Connection
Motor Cable Plug
Motor
Cable Plug
Power
Connection
Power
Connection
Base Extrusion
Base
Extrusion
Strain Relief
Bracket
Screw
Power
Connection
Foot Pedal
Connection
Power
Cable
Center
Housing
6j
6l
7o
7p
6
7
To Next Page
Loading...
Need help?
General
