AUdIO mOdES cOPILOT TROUBLESHOOTINg TEcHNIcAL ASSISTANcE
17
TECHNICAL ASSISTANCE
Do not take your CoPilot receiver or remote to your dealer or to a Minn Kota Authorized Service Center for repair or replace-
ment. The CoPilot remote has no field replaceable or user serviceable parts, (other than battery replacement). For service/
technical assistance call 1-800-227-6433, or send the CoPilot receiver and remote(s) along with proof of purchase date to:
Johnson Outdoors- MinnKota Service, 121 Power Drive, Mankato MN 56002-8129
CAUSE EFFECT SOLUTION
The battery is discharged Replace battery
Receiver may not have “learned”
the ID number of the remote.
Remote needs to be learned.
See “ “ADDING/REMOVING REMOTES”
section to learn the remote ID
number.
REMOTE IS NOT
TRANSMITTING
If remote has been taken apart,
the keypad and top case may
have been installed backwards.
Take remote apart (BATTERY
REPLACEMENT SECTION) and
reinstall case halves with the
proper orientation.
Prop speed is set at “0”
Increase the prop speed above
“0”
THE PROP IS NOT TURNING
BUT THE “PROP ON” AUDIO
TICK IS STILL GOING
Prop ON tick occurs only in
Audio mode 3
Switch Audio mode to either
Audio 1 or 2. See “Audio
Modes” section.
AUDIO
PATTERN
WHAT CONDITION CAUSES IT
WHICH AUDIO
MODE
2 second long
beep
Every time the receiver is powered up an there are no remote
IDs learned.
All
5 beeps
Foot pedal speed control is moved after speed has been
adjusted with remote All
Steady tone Heard while holding down the learn button on the receiver. All
4 beeps After a remote button is pressed while the receiver learns it's ID. All
A ten second
long warbling
sound that
transitions into a
steady tone
Heard during the process used to clear all stored remote IDs.
After the learn switch is released, a 2 second long beep will be
heard.
All
To Next Page
Loading...
Need help?
General
