INSTALLING MIVOICE MX-ONE HARDWARE, OVERVIEW
3 6/1531-ASP11301 Uen T2 2015-04-23
1 INTRODUCTION
MX-ONE is a communication solution for enterprises. MX-ONE integrates voice
communication in fixed and mobile networks for public as well as private service.
MX-ONE can be integrated into an existing Local Area Network (LAN) infrastructure.
MX-ONE supports both IP telephony and functions found in classic circuit-switched
PBXes (Private Branch Exchanges).
1.1 SCOPE
This document describes the MX-ONE installation procedure structure and shows the
steps needed for a HW installation. For details of each area, see the following docu-
ments:
• Installation preparation and Earthing, 19/1531-ASP11301
• Installation chassis in a Cabinet, 20/1531-ASP11301
• Installation boards and Cabling, 21/1531-ASP11301
1.2 TARGET GROUP
The target group for this document is personnel involved in installing the MX-ONE.
1.3 PREREQUISITES
This section lists requirements that must be fulfilled before the installation starts.
1.3.1 TRAINING
Personnel working with Mitel MX-ONE systems must have the training required to
perform their tasks correctly.
It is recommended for engineers installing the MX-ONE to be acquainted with the
following areas:
• MX-ONE Service Node
• Media Gateway in MX-ONE
• Certification
• TCP/IP Networks
1.3.2 ELECTRICAL CONNECTIONS
Installation procedures involving connection of power cables, batteries and earthing,
must be performed according to local regulations.
To Next Page
Loading...
Need help?
General
