INSTALLING MIVOICE MX-ONE HARDWARE, OVERVIEW
15 6/1531-ASP11301 Uen T2 2015-04-23
8 CONNECTION OF EXTERNAL CABLES
Cabling to the MDF uses prefabricated cables.
Twisted, shielded, pair-cables are to be used for cabling between the PBX and MDF or
between two PBX’s (Media Gateway - Media Gateway).
For information about cables see document 21/1531-ASP11301INSTALLATION
BOARDS AND CABLING.
9 ALARM INSTALLATION
General alarms can be monitored in several ways depending on how the system is
configured. In systems with MX-ONE Classic (7U chassis) and MGU board, the
simplest way is to use the alarm input on the DC/DC-board and configure the MGU
board.
When many external alarm shall be monitored or when system is not equipped with
MGU board, an ALU2 board can be used.
If more in- or out- signals are required, the number of ALU2 boards can be increased.
Alarm indications are normally transferred to the PBX operator consoles when using
ALU2.
In systems with MGU boards, the system can supervise several alarms, both external
and internal.
For details about alarm and the installation, see document INSTALLATION BOARDS
AND CABLING.
10 SOFTWARE INSTALLATION AND CONFIGU-
RATION
For software installation and configuration of MX-ONE, see the installation instructions
for INSTALLING AND CONFIGURING MIVOICE MX-ONE.
For software installation and configuration of MX-ONE Messaging, see the installation
instructions for Fax Mail and Voice Mail.
To Next Page
Loading...
Need help?
General
