MIVOICE 4420 IP BASIC (DBC 420) FOR MIVOICE MX-ONE
7 9/1553-ANF 901 54 Uen L1 2016-03-09
Figure 2: Connecting the Telephone
If a headset will be used, connect it according to 2 Connecting the Telephone on page 7
If your PC will use the same LAN outlet as your telephone, connect the PC as shown
in 2 Connecting the Telephone on page 7
Note: When the telephone is starting, a connected PC will loose the LAN connection
for approximately 10 seconds.
2.6 STARTING THE TELEPHONE
Make sure that the telephone is connected to the IP network (LAN).
2.6.1 STARTING THE TELEPHONE
About 5 seconds after the telephone is connected to the power, the Mute lamp is lit for
5 seconds.
The administrator mode is used to change the IP settings in the telephone. This mode
is reserved for the maintenance personnel.
If the status lamp is flashing slowly, it indicates that the telephone is not ready for use.
If the lamp is double flashing, there is no LAN connection. Check the cabling.
The IP telephone gets the IP addresses from the network.
The telephone checks if new software has to be loaded. If the software needs to be
updated, the procedure is fully automatic. The software is loaded internally in the tele-
phone.
To Next Page
Need help?
General
