– 15 –
How to Run / Stop All
This runs or stops all the indoor units being managed.
Method A
< RUN > Press the RUN ALL button.
All the indoor units being managed run and the RUN/ERROR display lamp lights up green.
< STOP > Press the STOP ALL button.
All the indoor units being managed stop and the RUN/ERROR display lamp goes out.
Method B
1 2
< RUN >
1. Press the ALL / GROUP / ONE button and select ALL.
The options are displayed in the order.
2. Press the RUN button.
< STOP >
1. Press the ALL / GROUP / ONE button and select ALL.
The options are displayed in the order.
2. Press the STOP button.
Note
The CENTER / REMOTE setting for indoor units can only be made for indoor units set to CENTER or CENTER
and REMOTE.
This operation is disabled on indoor units set to REMOTE.
•
RUN
STOP
To Next Page
Loading...
Need help?
General
