-
127
-
'10 • SR-T-091
(5) Flap and louver control
Control the ap and louver by AIRFLOW
(UP/DOWN) and
(LEFT/RIGHT) button on the wireless remote controller.
(a) Flap
Each time when you press the AIRFLOW
(UP/DOWN) button the mode changes as follows.
(b) Louver
Each time when you press the AIRFLOW
(LEFT/RIGHT) button the mode changes as follows.
(c) Swing
1)
Swing ap
Flap moves in upward and downward
directions continuously.
2)
Swing louver
Louver moves in left and right directions continuously.
(d) Memory flap (Flap or Louver stopped)
When you press the AIRFLOW (UP/DOWN or LEFT/RIGHT) button once while the ap or louver is operating, it stops swinging
at the position. Since this angle is memorized in the microcomputer, the ap or louver will automatically be set at this angle when
the next operation is started.
(e) When not operating
The ap returns to the position of air ow directly below, when operation has stopped.
To Next Page
Loading...
Need help?
General
