4D68 ENGINE (E-W) -
Timing Belt
11A-4-6
"
F
A
INJECTION PUMP SPROCKET NUT TIGHTENING
"
G
A
CAMSHAFT SPROCKET BOLT TIGHTENING
"
H
A
TIMING BELT TENSIONER INSTALLATION
(1) Set the tensioner spring ends against the tensioner bracket
and the projection of the injection pump bracket.
(2) Attach a bolt to the front end face of the timing belt
tensioner. Fit an offset wrench onto the bolt and turn the
wrench downward as shown to tighten the tensioner
mounting bolt temporarily.
Caution
D
Use such a short bolt as would not come into
contact with the timing belt tensioner mounting
bolt at the rear end face when it is tightened.
"
I
A
TIMING BELT INSTALLATION
(1) Temporarily fix th e tensioner at the most lower position
in the injection pump bracket slot.
(2) Turn the crankshaft to bring the No. 1 piston at the top
dead center on the compression stroke.
(3) Align the timing marks of all sprockets with their mating
marks as shown.
NOTE
If the injection pump sprocket is released, it turns about
one tooth in a counterclockwise direction. Therefore, the
timing mark of the injection pump sprocket should be
aligned when the timing belt is installed.
PWEE9609
E
Dec. 1996Mitsubishi Motors Corporation
DEN0754
MD998719
MB990767
DEN0755
MD998719
MB990767
DEN0838
DEN0756
Timing mark
Timing
mark
Timing mark
Camshaft
sprocket
Camshaft
sprocket
Timing
mark
Oil pump sprocket
Injection
pump
sprocket
To Next Page
Loading...
Need help?
General
