EasyManuals Logo
Home>Mitsubishi>Automobile>ASX

Mitsubishi ASX User Manual

Mitsubishi ASX
368 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #134 background imageLoading...
Page #134 background image
Indication lamps
E00501600100
Turn-signal indication lamps/
Hazard warning indication
lamps
E00501700361
These
indication lamps blink in the fol-
lowing situations.
l
When the turn-signal lever is
moved to activate a turn-signal
lamp.
Refer to “Turn-signal lever” on
page 3-49.
l
When the hazard warning flasher
switch is pressed to activate the
hazard warning lamps.
Refer to “Hazard warning flasher
switch” on page 3-50.
l
When the hazard warning lamps
automatically activate due to sud-
den braking while driving.
Refer to “Emergency stop signal
system” on page 4-37.
NOTE
l
If these indication lamps blink too
fast due to any operation other
than sudden braking, the cause
may be a blown lamp bulb or a faul-
ty turn-signal connection.
High-beam indication lamp
E00501800173
This
indication lamp illuminates when
the high-beam is used.
Front fog lamp indication
lamp*
E00501900350
This
lamp illuminates while the front
fog lamps are on.
Rear fog lamp indication lamp
E00502000185
This
lamp illuminates while the rear fog
lamp is on.
Position lamp indication lamp
E00508900173
This indication lamp illuminates while
the position lamps are on.
Diesel preheat indication lamp
(diesel-powered vehicles)
E00502300247
This
indicates the glow plug preheat con-
dition.
[Except for vehicles equipped with key-
less operation system]
When the ignition switch is turned to the
“ON” position, the lamp illuminates. As
the glow plug becomes hot, the lamp
goes out and the engine can be started.
[For vehicles equipped with keyless op-
eration system]
When the operation mode is put in ON,
the lamp illuminates and preheating of
the glow lamp starts automatically. As
the glow plug becomes hot, the lamp
goes out and the engine starts.
NOTE
l
If
the engine is cold, the diesel pre-
heat indication lamp is on for a lon-
ger time.
l
When the engine is warm, the die-
sel preheat indication lamp does
not come on even if the ignition
switch is turned to the “ON” posi-
tion or the operation mode is put
in ON.
Instruments and controls
3-40
3

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mitsubishi ASX and is the answer not in the manual?

Mitsubishi ASX Specifications

General IconGeneral
BrandMitsubishi
ModelASX
CategoryAutomobile
LanguageEnglish

Related product manuals