Foot/demister position
Air flows to the leg area, the windscreen and the
door windows.
Demister position
Air
flows mainly to the windscreen and the door
windows.
CAUTION
l
When
using the mode selection dial be-
tween the “
”
and “
”
positions, pre-
vent fogging by pressing the air selection
switch to select outside air.
(Refer to “Air selection switch” on page
5-04.)
NOTE
l
With
the mode selection dial between the
“
”
and “
”
positions, the air flows main-
ly to the upper part of the passenger compart-
ment. With the mode selection dial between
the “
”
and “
”
positions, the air flows
mainly to the leg area.
l
With the mode selection dial in the “
”
po-
sition, a small amount of air flows to the wind-
screen and the door windows.
l
With the mode selection dial between the
“
”
and “
”
positions, the air flows main-
ly to the leg area. With the mode selection di-
al between the “
”
and “
”
positions, the
air flows mainly to the windscreen and door
windows.
Heater/Air conditioning
E00700500449
The
heater/air conditioning can only be used while
the engine is running.
Control panel
E00700600541
Heater/Manual air conditioning
Automatic air conditioning
A- Temperature control dial
B-
Air selection switch
C- Blower speed selection dial
D- Air conditioning switch
E- Mode selection dial
F-
Rear window demister switch ® p. 3-57
NOTE
l
On vehicles with the heater, button (D) is not
available for use. The indicator below the but-
ton doesn’t come on even if it is pushed.
l
On
vehicles with automatic air conditioning,
there is an interior air temperature sensor (G)
in the illustrated position.
Never place anything over the sensor, since
doing so will prevent it from functioning prop-
erly.
Blower speed selection dial
E00700700249
Select the blower speed by turning the blower
speed selection dial clockwise or anticlockwise.
Turn
the dial clockwise to increase the air flow and
anticlockwise to decrease the air flow.
Heater/
Manual air conditioning
Automatic air conditioning
For pleasant driving
5-03
5