15- Active Stability Control (ASC) OFF in-
dication lamp ® p. 6-54
16- Anti-lock brake system (ABS) warning
lamp ® p. 6-51
17- Supplement Restraint System (SRS)
warning lamp ® p. 4-35
18- Check engine warning lamp ® p. 5-47
19- Seat belt warning lamp ® p. 4-10
20- Tyre pressure monitoring system warn-
ing lamp* ® p. 6-104
21- Brake auto hold indication lamp*
® p. 6-44
22- Brake warning lamp ® p. 5-46
Information screen display
E00523901504
When there is information to be announced, such as lamp reminder, the buzzer sounds and the screen switches to the displays shown below.
Refer to the appropriate page and take the necessary measures.
When the cause of the warning display is eliminated, the warning display goes out automatically.
Refer to “Warning display list” on page 5-24.
Refer to “Navigation information display” on page 5-41.
Refer to “Other interrupt displays” on page 5-42.
NOTE
l
A warning may be displayed on the information screen and the buzzer may sound in the following rare cases.
This is caused by the system picking up interference such as noise or strong electromagnetic waves, and is not a functional problem.
•
An extremely strong electromagnetic wave is received from a source such as an illegal radio set, a spark from a wire, or a radar station.
•
Abnormal voltage or a static electricity discharge is generated by the operation of installed electrical equipment (including after-market parts).
If the warning display appears many times, we recommend you to consult a MITSUBISHI MOTORS Authorized Service Point.
Indication lamp, warning lamp, and information screen display list
5-23
OGKE18E1
Instruments and controls
5
To Next Page
Loading...
Need help?
General
