Mitsubishi ECLIPSE CROSS 2017 User Manual

Coming home light
E00529001897
This function turns on the headlamps in the
low beam setting for approximately 30 sec-
onds after the ignition switch is turned to the
“LOCK” position or the operation mode is
put in OFF.
1. Turn the combination headlamps and
dipper switch to the “AUTO” position.
2. Turn the ignition switch to the “LOCK”
position or put the operation mode in
OFF. Also, if a key was used to start the
engine, remove the key from the ignition
switch.
3. Within 60 seconds of turning the igni-
tion switch to the “LOCK” position or
putting the operation mode in OFF, pull
the turn signal lever towards you.
4. The headlamps will come on in the low
beam setting for approximately 30 sec-
onds. After the headlamps go off, the
headlamps can be turned on again in the
low beam setting for approximately 30
seconds by pulling the turn signal lever
towards you within 60 seconds of turn-
ing the ignition switch to the “LOCK”
position or putting the operation mode in
OFF.
To turn on the headlamps again after 60
seconds of turning the ignition switch to
the “LOCK” position or putting the op-
eration mode in OFF, repeat the process
from step 1.
NOTE
l
While the coming home light function is op-
erating, perform one of the following opera-
tions to cancel the function.
•
Pull the turn-signal lever towards you.
•
Turn the combination headlamps and dip-
per switch to the “
” or “ ” position.
•
Turn the ignition switch to the “ON” posi-
tion or put the operation mode in ON.
l
It is possible to modify functions as follows:
•
The time that the headlamps remain on
can be changed.
•
The coming home light function can be
deactivated.
NOTE
For further information, please contact your
MITSUBISHI MOTORS Authorized Serv-
ice Point.
On vehicles equipped with the Smartphone
Link Display Audio or the MITSUBISHI
Multi-Communication System (MMCS),
screen operations can be used to make the
adjustment. Refer to the separate owner’s
manual for details.
Headlamp levelling
E00517400031
Headlamp levelling switch (ex-
cept for vehicle with LED
headlamps)
E00517502049
The angle of the headlamp beam varies de-
pending on the load carried by the vehicle.
The headlamp levelling switch can be used to
adjust the headlamp illumination distance
(when the lower beam is illuminated) so that
the headlamps’ glare does not distract other
drivers.
Headlamp levelling
5-62
OGKE18E1
Instruments and controls
5

Mitsubishi ECLIPSE CROSS 2017 Specifications

General

Brand	Mitsubishi
Model	ECLIPSE CROSS 2017
Category	Automobile
Language	English