NOTE
l
The mode of the detection area can be
switched only when the selector lever is in
the “R” (Reverse) position.
l
The detection area will not change if you
keep the “SONAR” switch pressed for 10
seconds or more.
l
After pressing the “SONAR” switch, the
parking sensors operation differs according
to the detection area setting.
•
Setting when towing bar is not equipped
When the selector lever is moved to the
“R” (Reverse) position, the parking sen-
sors will operate even if corner sensor op-
eration was stopped by pressing the “SO-
NAR” switch.
•
Setting when towing bar is equipped
When parking sensors operation was stop-
ped by pressing the “SONAR” switch, the
parking sensors will not operate until the
engine has been stopped even if the selec-
tor lever is moved to the “R” (Reverse)
position.
To resume parking sensors operation,
press the “SONAR” switch or stop and re-
start the engine, and then move the selec-
tor lever to the “R” (Reverse) position.
Warning display
E00648300200
In case there is a malfunction in the parking
sensors, the display for the malfunctioning
sensor will blink and the warning buzzer will
sound for approximately 5 seconds.
Example: Rear corner sensor (left) mal-
functioning
Even after the buzzer and display has stopped
warning, the indication lamp (A) on “SO-
NAR” switch will continue blinking until the
system reverts to the normal state. Have the
vehicle inspected at a MITSUBISHI
MOTORS Authorized Service Point.
Rear-view camera*
E00618402381
The rear-view camera is a system that shows
the view behind the vehicle on a screen of the
DISPLAY AUDIO, the Smartphone Link
Display Audio or the MITSUBISHI Multi-
Communication System (MMCS).
Rear-view camera*
6-113
OGKE18E1
Starting and driving
6
To Next Page
Loading...
Need help?
General
