NOTE
l
When the selector lever is other than “P”
(Park) position, if you try to release the
Electric parking brake without depressing
the brake pedal, the warning display will ap-
pear.
l
If you start driving without releasing the
Electric parking brake, the warning display
will appear.
l
If the driver’s foot contacts the accelerator
pedal in the condition that the Electric park-
ing brake can be released by an automatic
operation, the Electric parking brake may be
released automatically.
Warning lamp/display
Warning lamp (yellow)
Warning display
If there is a malfunction in the system, the
warning lamp will come on. In addition, the
warning display appears on the information
screen in the multi-information display.
Under normal conditions, the warning lamp
only comes on when the ignition switch is
turned to the “ON” position or the operation
mode is put in ON and goes off a few sec-
onds later.
CAUTION
l
When the Electric parking brake warning
lamp (yellow) does not illuminate or remains
illuminated when the ignition switch is
turned to the “ON” position or the operation
mode is put in ON, or comes on while driv-
ing, the Electric parking brake may not be
applied or released. Immediately contact the
nearest MITSUBISHI MOTORS Authorized
Service Point. For details, refer to “Electric
parking brake warning light (yellow)” on
page 5-47.
When parking your vehicle while the Elec-
tric parking brake warning lamp (yellow) is
illuminated, park the vehicle on level and
stable ground, move the selector lever to the
“P” (PARK) position and place chocks,
blocks or stones behind and in front of the
tyres to prevent the vehicle from moving.
Parking
E00600602834
To park the vehicle, firmly apply the parking
brake, and then move the gearshift lever to 1
st
or “R” (Reverse) position for vehicles equip-
ped with M/T, or set the selector lever to “P”
(PARK) position for vehicles equipped with
CVT.
Parking on a hill
To prevent the vehicle from rolling, follow
these procedures:
Parking
6-08
OGKE18E1
Starting and driving
6