4. Insert a new fuse of the same capacity
by using the fuse puller into the same
place the fuse block.
CAUTION
l
If the newly inserted fuse blows again after a
short time, we recommend you to have the
electrical system checked to find the cause
and rectify it.
l
Never use a fuse with a larger capacity than
specified or a substitute (such as a cable or
foil). Doing so could cause the circuit wires
to overheat and create a fire.
Replacement of lamp bulbs
E01003102206
Before replacing a bulb, ensure the lamp is
off. Do not touch the glass part of the new
bulb with your bare fingers; the skin oil left
on the glass will evaporate when the bulb
gets hot and the vapour will condense on the
reflector and dim the surface.
CAUTION
l
Do not install commercially available LED
type bulbs.
Commercially available LED type bulbs
could adversely affect the operation of the
vehicle, such as by preventing the lamps and
other vehicle equipment from operating
properly.
l
Bulbs are extremely hot immediately after
being turned off.
When replacing a bulb, wait for it to cool
sufficiently before touching it. You could
otherwise be burnt.
l
Handle halogen lamp bulbs with care. The
gas inside a halogen lamp bulb is highly
pressurized, so dropping, knocking, or
scratching a halogen lamp bulb can cause it
to shatter.
CAUTION
l
Never hold the halogen lamp bulb with a
bare hand, dirty glove, etc. The oil from
your hand could cause the bulb to break the
next time the headlamps are operated.
If the glass surface is dirty, it must be
cleaned with alcohol, paint thinner, etc., and
refit it after drying thoroughly.
NOTE
l
If you are unsure of how to carry out the
work as required, we recommend you to
consult a specialist.
l
Be careful not to scratch the vehicle body
when removing a lamp or lens.
Replacement of lamp bulbs
10-22
OGKE18E1
Maintenance
10
To Next Page
Loading...
Need help?
General
