CAUTION
•
If the windscreen is misted, remove the
mist from the windscreen by using the de-
mister switch.
•
Maintain the wiper blades in good condi-
tion.
Refer to “Wiper blades” on page 9-06.
When replacing the wiper blades, use on-
ly MITSUBISHI MOTORS GENUINE
parts or equivalent.
•
Do not dirty or damage the sensor.
•
Do not spray glass cleaner on the sensor.
Also, do not spill liquid, such as a bever-
age, on the sensor.
•
Do not install an electronic device, such
as an antenna, or a device that emits
strong electric waves near the sensor.
•
Always use tyres of the same size, same
type and same brand and that have no sig-
nificant wear differences.
•
Do not modify the vehicle’s suspensions.
l
If the windscreen on the sensor or in the sur-
rounding area of the sensor is cracked or
scratched, the sensor may not detect an ob-
ject properly. This could cause a serious ac-
cident. Turn off the FCM and have your ve-
hicle inspected as soon as possible at a
MITSUBISHI MOTORS Authorized Serv-
ice Point.
If you need to replace the windscreen, con-
tact a MITSUBISHI MOTORS Authorized
Service Point.
CAUTION
l
The sensor emits infrared rays when the ig-
nition switch is turned to the “ON” position
and the operation mode is put in ON. Do not
look into the sensor by using optical goods
such as a magnifying glass. The infrared ray
might injure your eyes.
Laser radar specifications
Laser classification
Max average power 45 mW
Pulse duration 33 ns
Wavelength 905 nm
Divergent angle
(horizon x vertical)
28° x 12°
Laser classification label
For Europe
For Israel
Laser explanatory label
Forward Collision Mitigation System (FCM)
6-87
OGKE18E1
Starting and driving
6
To Next Page
Loading...
Need help?
General
